The voice-signaling application type is for network topologies that require a different policy for voice signaling
than for voice media. This application type should not be advertised if all of the same network policies apply
as those advertised in the voice policy TLV.
When you are in network-policy profile configuration mode, you can create the profile for voice-signaling
by specifying the values for VLAN, class of service (CoS), differentiated services code point (DSCP), and
tagging mode.
These profile attributes are contained in the Link Layer Discovery Protocol for Media Endpoint Devices
(LLDP-MED) network-policy time-length-value (TLV).
To return to privileged EXEC mode from the network-policy profile configuration mode, enter the exit
command.
Examples
This example shows how to configure voice-signaling for VLAN 200 with a priority 2 CoS:
Device(config)# network-policy profile 1
Device(config-network-policy)# voice-signaling vlan 200 cos 2
This example shows how to configure voice-signaling for VLAN 400 with a DSCP value of 45:
Device(config)# network-policy profile 1
Device(config-network-policy)# voice-signaling vlan 400 dscp 45
This example shows how to configure voice-signaling for the native VLAN with priority tagging:
Device(config-network-policy)# voice-signaling vlan dot1p cos 4
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
135
voice-signaling vlan (network-policy configuration)
To Next Page
Loading...
Need help?
General