Cisco Catalyst 3650 Series User Manual

location plm calibrating
To configure path loss measurement (CCX S60) request for calibrating clients, use the location plm calibrating
command in global configuration mode.
location plm calibrating {multiband | uniband}
Syntax Description
Specifies the path loss measurement request for calibrating clients on the
associated 802.11a or 802.11b/g radio.
multiband
Specifies the path loss measurement request for calibrating clients on the
associated 802.11a/b/g radio.
uniband
Command Default
No default behavior or values.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
The uniband is useful for single radio clients (even if the radio is a dual band and can operate in the 2.4-GHz
and the 5-GHz bands). The multiband is useful for multiple radio clients.
Examples
This example shows how to configure the path loss measurement request for calibrating clients on the associated
802.11a/b/g radio:
Device# configure terminal
Device(config)# location plm calibrating uniband
Device(config)# end
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
929
location plm calibrating

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English