Cisco Catalyst 3650 Series User Manual

match ipv6 hop-limit
To configure the IPv6 hop limit as a key field for a flow record, use the match ipv6 hop-limit command in
flow record configuration mode. To disable the use of a section of an IPv6 packet as a key field for a flow
record, use the no form of this command.
match ipv6 hop-limit
no match ipv6 hop-limit
Syntax Description
This command has no arguments or keywords.
Command Default
The use of the IPv6 hop limit as a key field for a user-defined flow record is not enabled by default.
Command Modes
Flow record configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A flow record requires at least one key field before it can be used in a flow monitor. The key fields distinguish
flows, with each flow having a unique set of values for the key fields. The key fields are defined using the
match command.
Examples
The following example configures the hop limit of the packets in the flow as a key field:
Device(config)# flow record FLOW-RECORD-1
Device(config-flow-record)# match ipv6 hop-limit
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
452
match ipv6 hop-limit

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English