Cisco Catalyst 3650 Series User Manual

snmp-server engineID
To configure a name for either the local or remote copy of SNMP, use the snmp-server engineID command
in global configuration mode.
snmp-server engineID {local engineid-string | remote ip-address [udp-port port-number] engineid-string}
Syntax Description
Specifies a 24-character ID string with the name of the copy of SNMP. You
need not specify the entire 24-character engine ID if it has trailing zeros.
Specify only the portion of the engine ID up to the point where only zeros
remain in the value.
local engineid-string
Specifies the remote SNMP copy. Specify the ip-address of the device that
contains the remote copy of SNMP.
remote ip-address
(Optional) Specifies the User Datagram Protocol (UDP) port on the remote
device. The default is 162.
udp-port port-number
Command Default
None
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
None
Examples
The following example configures a local engine ID of 123400000000000000000000:
Device(config)# snmp-server engineID local 1234
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
559
snmp-server engineID

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English