Cisco Catalyst 3650 Series User Manual

snmp-server enable traps vstack
To enable SNMP smart install traps, use the snmp-server enable traps vstack command in global configuration
mode. Use the no form of this command to return to the default setting.
snmp-server enable traps vstack [addition][failure][lost][operation]
no snmp-server enable traps vstack [addition][failure][lost][operation]
Syntax Description
(Optional) Enables client added traps.addition
(Optional) Enables file upload and download failure traps.failure
(Optional) Enables client lost trap.lost
(Optional) Enables operation mode change traps.operation
Command Default
The sending of SNMP smart install traps is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples
This example shows how to generate SNMP Smart Install client-added traps:
Device(config)# snmp-server enable traps vstack addition
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
558
snmp-server enable traps vstack

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English