errdisable detect cause
To enable error-disable detection for a specific cause or for all causes, use the errdisable detect cause
command in global configuration mode. To disable the error-disable detection feature, use the no form of this
command.
errdisable detect cause {all| arp-inspection| bpduguard shutdown vlan| dhcp-rate-limit| dtp-flap|
gbic-invalid| inline-power| l2ptguard| link-flap| loopback| pagp-flap| pppoe-ia-rate-limit |
security-violation shutdown vlan| sfp-config-mismatch}
no errdisable detect cause {all| arp-inspection| bpduguard shutdown vlan| dhcp-rate-limit| dtp-flap|
gbic-invalid| inline-power| l2ptguard| link-flap| loopback| pagp-flap| pppoe-ia-rate-limit |
security-violation shutdown vlan| sfp-config-mismatch}
Syntax Description
Enables error detection for all error-disabled causes.all
Enables error detection for dynamic Address Resolution Protocol (ARP)
inspection.
arp-inspection
Enables per-VLAN error-disable for BPDU guard.bpduguard shutdown vlan
Enables error detection for DHCP snooping.dhcp-rate-limit
Enables error detection for the Dynamic Trunking Protocol (DTP)
flapping.
dtp-flap
Enables error detection for an invalid Gigabit Interface Converter (GBIC)
module.
This error refers to an invalid small form-factor pluggable (SFP)
module.
Note
gbic-invalid
Enables error detection for the Power over Ethernet (PoE) error-disabled
cause.
This keyword is supported only on switches with PoE
ports.
Note
inline-power
Enables error detection for a Layer 2 protocol-tunnel error-disabled cause.l2ptguard
Enables error detection for link-state flapping.link-flap
Enables error detection for detected loopbacks.loopback
Enables error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
pagp-flap
Enables error detection for the PPPoE Intermediate Agent rate-limit
error-disabled cause.
pppoe-ia-rate-limit
Enables voice aware 802.1x security.security-violation shutdown
vlan
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
36
errdisable detect cause