destination
To configure an export destination for a flow exporter, use the destination command in flow exporter
configuration mode. To remove an export destination for a flow exporter, use the no form of this command.
destination {hostname| ip-address} vrf vrf-label
no destination {hostname| ip-address} vrf vrf-label
Syntax Description
Hostname of the device to which you want to send the NetFlow information.
hostname
IPv4 address of the workstation to which you want to send the NetFlow information.
ip-address
(Optional) Specifies that the export data packets are to be sent to the named Virtual
Private Network (VPN) routing and forwarding (VRF) instance for routing to the
destination, instead of to the global routing table.
vrf
Name of the VRF instance.
vrf-label
Command Default
An export destination is not configured.
Command Modes
Flow exporter configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
Each flow exporter can have only one destination address or hostname.
When you configure a hostname instead of the IP address for the device, the hostname is resolved immediately
and the IPv4 address is stored in the running configuration. If the hostname-to-IP-address mapping that was
used for the original Domain Name System (DNS) name resolution changes dynamically on the DNS server,
the device does not detect this, and the exported data continues to be sent to the original IP address, resulting
in a loss of data.
To return this command to its default setting, use the no destination or default destination command in flow
exporter configuration mode.
Examples
The following example shows how to configure the networking device to export the Flexible NetFlow cache
entry to a destination system:
Device(config)# flow exporter FLOW-EXPORTER-1
Device(config-flow-exporter)# destination 10.0.0.4
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
425
destination
To Next Page
Loading...
Need help?
General