Cisco Catalyst 3650 Series User Manual

ip nhrp map
To statically configure the IP-to-nonbroadcast multiaccess (NBMA) address mapping of IP destinations
connected to an NBMA network, use the ip nhrp map command in interface configuration mode. To remove
the static entry from Next Hop Resolution Protocol (NHRP) cache, use the no form of this command.
ip nhrp map ip-address {ip-nbma-address | destination-mask [ip-nbma-address | ipv6-nbma-address] |
ipv6-nbma-address}
no ip nhrp map ip-address {ip-nbma-address | destination-mask [ip-nbma-address | ipv6-nbma-address] |
ipv6-nbma-address}
Syntax Description
IP address of the destinations reachable through the
NBMA network. This address is mapped to the
NBMA address.
ip-address
NBMA address that is directly reachable through the
NBMA network. The address format varies depending
on the medium; for example, ATM has a Network
Service Access Point (NSAP) address, Ethernet has
a MAC address, and Switched Multimegabit Data
Service (SMDS) has an E.164 address. This address
is mapped to the IP address.
ip-nbma-address
Destination address mask.
destination-mask
IPv6 NBMA address.
This argument is not supported in Cisco IOS
XE Denali 16.3.1.
Note
ipv6-nbma-address
Command Default
No static IP-to-NBMA cache entries exist.
Command Modes
Interface configuration(config-if)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
In Cisco IOS XE Denali 16.3.1, NHRP supports only hub-to-spoke communication; spoke-to-spoke
communication is not supported.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
175
ip nhrp map

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English