Cisco Catalyst 3650 Series User Manual

match ipv6
To configure one or more of the IPv6 fields as a key field for a flow record, use the match ipv6 command in
flow record configuration mode. To disable the use of one or more of the IPv6 fields as a key field for a flow
record, use the no form of this command.
match ipv6 {destination address| hop-limit| protocol| source address| traffic-class| version}
no match ipv6 {destination address| hop-limit| protocol| source address| traffic-class| version}
Syntax Description
Configures the IPv4 destination address as a key field. For more
information see match ipv6 destination address, on page 451.
destination address
Configures the IPv6 hop limit as a key field. For more information see
match ipv6 hop-limit, on page 452.
hop-limit
Configures the IPv6 protocol as a key field.protocol
Configures the IPv4 destination address as a key field. For more
information see match ipv6 source address, on page 453.
source address
Configures the IPv6 traffic class as a key field.traffic-class
Configures the IPv6 version from IPv6 header as a key field.version
Command Default
The IPv6 fields are not configured as a key field.
Command Modes
Flow record configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A flow record requires at least one key field before it can be used in a flow monitor. The key fields distinguish
flows, with each flow having a unique set of values for the key fields. The key fields are defined using the
match command.
Examples
The following example configures the IPv6 protocol field as a key field:
Device(config)# flow record FLOW-RECORD-1
Device(config-flow-record)# match ipv6 protocol
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
450
match ipv6

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English