Cisco Catalyst 3650 Series User Manual

match ipv6 source address
To configure the IPv6 source address as a key field for a flow record, use the match ipv6 source address
command in flow record configuration mode. To disable the use of the IPv6 source address as a key field for
a flow record, use the no form of this command.
match ipv6 source address
no match ipv6 source address
Syntax Description
This command has no arguments or keywords.
Command Default
The IPv6 source address is not configured as a key field.
Command Modes
Flow record configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
A flow record requires at least one key field before it can be used in a flow monitor. The key fields distinguish
flows, with each flow having a unique set of values for the key fields. The key fields are defined using the
match command.
To return this command to its default settings, use the no match ipv6 source address or default match ipv6
source address flow record configuration command.
Examples
The following example configures a IPv6 source address as a key field:
Device(config)# flow record FLOW-RECORD-1
Device(config-flow-record)# match ipv6 source address
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
453
match ipv6 source address

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English