Cisco Catalyst 3650 Series User Manual

show sdm prefer
To display information about the templates that can be used to maximize system resources for a particular
feature, use the show sdm prefer command in privileged EXEC mode. To display the current template, use
the command without a keyword.
show sdm prefer [advanced]
Syntax Description
(Optional) Displays information on the advanced template.advanced
Command Default
No default behavior or values.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
If you did not reload the switch after entering the sdm prefer global configuration command, the show sdm
prefer privileged EXEC command displays the template currently in use and not the newly configured
template.
The numbers displayed for each template represent an approximate maximum number for each feature resource.
The actual number might vary, depending on the actual number of other features configured. For example,
in the default template if your device had more than 16 routed interfaces (subnet VLANs), the number of
possible unicast MAC addresses might be less than 6000.
Examples
The following is sample output from the show sdm prefer command:
Device# show sdm prefer
Showing SDM Template Info
This is the Advanced template.
Number of VLANs: 4094
Unicast MAC addresses: 32768
Overflow Unicast MAC addresses: 512
IGMP and Multicast groups: 8192
Overflow IGMP and Multicast groups: 512
Directly connected routes: 32768
Indirect routes: 7680
Security Access Control Entries: 3072
QoS Access Control Entries: 3072
Policy Based Routing ACEs: 1024
Netflow ACEs: 1024
Input Microflow policer ACEs: 256
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
968
show sdm prefer

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English