Cisco Catalyst 3650 Series User Manual

show interfaces rep detail
To display detailed REP configuration and status for all the interfaces or the specified interface, including the
administrative VLAN, use the show interfaces rep detail command in privileged EXEC mode.
show interfaces [interface-id] rep detail
Syntax Description
(Optional) Physical interface used to display the port ID.
interface-id
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was introducedCisco IOS XE Denali 16.2.2
Usage Guidelines
Enter this command on a segment edge port to send STCNs to one or more segments or to an interface. You
can verify your settings by entering the show interfaces rep detail privileged EXEC command.
Examples
The following example shows how to display the REP configuration and status for a specified interface.
Device# show interfaces TenGigabitEthernet4/1 rep detail
TenGigabitEthernet4/1 REP enabled
Segment-id: 3 (Primary Edge)
PortID: 03010015FA66FF80
Preferred flag: No
Operational Link Status: TWO_WAY
Current Key: 02040015FA66FF804050
Port Role: Open
Blocked VLAN: <empty>
Admin-vlan: 1
Preempt Delay Timer: disabled
Configured Load-balancing Block Port: none
Configured Load-balancing Block VLAN: none
STCN Propagate to: none
LSL PDU rx: 999, tx: 652
HFL PDU rx: 0, tx: 0
BPA TLV rx: 500, tx: 4
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 6, tx: 5
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 135, tx: 136
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
339
show interfaces rep detail

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English