Cisco Catalyst 3650 Series User Manual

debug lldp packets
To enable debugging of Link Layer Discovery Protocol (LLDP) packets, use the debug lldp packets command
in privileged EXEC mode. To disable debugging, use the no form of this command.
debug lldp packets
no debug lldp packets
Syntax Description
This command has no arguments or keywords.
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
The undebug lldp packets command is the same as the no debug lldp packets command.
When you enable debugging on a switch stack, it is enabled only on the active switch. To enable debugging
on a stack member, you can start a session from the active switch by using the session switch-number EXEC
command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
32
debug lldp packets

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English