Cisco Catalyst 3650 Series User Manual

autonomic connect
To connect a non autonomic device to autonomic domain use the autonomic connect command in interface
configuration mode. To disconnect a device from the domain, use the no form of this command.
autonomic connect
no autonomic connect
Command Default
Device is not connected to the domain.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
You need to configure no switchport on the interface before configuring the autonomic connect command.
Examples
To connect a non autonomic device to autonomic domain :
Device > enable
Device# configure terminal
Device(config)# int gig 1/0/1
Device(config-if)# no switchport
Device(config-if)# autonomic connect
Device(config-if)# ipv6 address 5000::1/64
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
889
autonomic connect

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English