Cisco Catalyst 3650 Series User Manual

show glbp
To display Gateway Load Balancing Protocol (GLBP) information, use the show glbp command in privileged
EXEC mode.
capability [interface-type interface-number]interface-type interface-number [ group-number ] [ state ] [brief]
Syntax Description
(Optional) Displays the GLBP capability interfaces.capability
(Optional) Interface type and number for which output
is displayed.
interface-type interface-number
(Optional) GLBP group number in the range from 0
to 1023.
group-number
(Optional) State of the GLBP device, one of the
following: active, disabled, init, listen, and standby.
state
(Optional) Summarizes each virtual gateway or virtual
forwarder with a single line of output.
brief
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was introduced..Cisco IOS XE Release 2.1
Usage Guidelines
Use the show glbp command to display information about GLBP groups on a device. The brief keyword
displays a single line of information about each virtual gateway or virtual forwarder. The capability keyword
displays all GLBP-capable interfaces.
Examples
The following is sample output from the show glbp command that displays GLBP group 10:
Device# show glbp GigabitEthernet 1/0/1 10
GigabitEthernet1/0/1 - Group 10
State is Active
1 state change, last state change 00:04:52
Virtual IP address is 10.21.8.10
Hello time 3 sec, hold time 10 sec
Next hello sent in 0.608 secs
Redirect time 600 sec, forwarder time-out 14400 sec
Preemption disabled
Active is local
Standby is unknown
Priority 100 (default)
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
187
show glbp

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English