show cts role-based permissions
To display the role-based (security group) access control permission list, use the show cts role-based
permissions command in privileged EXEC mode.
show cts role-based permissions [default [details | ipv4 [details]] | from [sgt [ipv4 | to [sgt | unknown]
[details | ipv4 [details]]] | unknown] | ipv4 | to [sgt | unknown] [ipv4]]
Syntax Description
(Optional) Displays information about the default permission list.default
(Optional) Displays attached access control list (ACL) details.details
(Optional) Displays information about the IPv4 protocol.ipv4
(Optional) Displays information about the source group.from
(Optional) Security Group Tag. Valid values are from 2 to 65519.
sgt
(Optional) Displays information about the destination group.to
(Optional) Displays information about unknown source and destination groups.unknown
Command Modes
Privileged EXE (#)
Command History
ModificationRelease
This command was introduced.Cisco IOS XE Denali 16.3.1
Usage Guidelines
This command displays the content of the SGACL permission matrix. You can specify the source security
group tag (SGT) by using the from keyword and the destination SGT by using the to keyword. When both
these keywords are specified RBACLs of a single cell are displayed. An entire column is displayed when only
the to keyword is used. An entire row is displayed when the from keyword is used. The entire permission
matrix is displayed when both the from and to keywords are omitted.
The command output is sorted by destination SGT as a primary key and the source SGT as a secondary key.
SGACLs for each cell is displayed in the same order they are defined in the configuration or acquired from
Cisco Identity Services Engine (ISE).
The details keyword is provided when a single cell is selected by specifying both from and to keywords.
When the details keyword is specified the access control entries of SGACLs of a single cell are displayed.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
811
show cts role-based permissions
To Next Page
Loading...
Need help?
General