Cisco Catalyst 3650 Series User Manual

debug flow exporter
To enable debugging output for Flexible NetFlow flow exporters, use the debug flow exporter command in
privileged EXEC mode. To disable debugging output, use the no form of this command.
debug flow exporter [[name] exporter-name] [error| event| packets number]
no debug flow exporter [[name] exporter-name] [error| event| packets number]
Syntax Description
(Optional) Specifies the name of a flow exporter.name
(Optional) The name of a flow exporter that was previously configured.
exporter-name
(Optional) Enables debugging for flow exporter errors.error
(Optional) Enables debugging for flow exporter events.event
(Optional) Enables packet-level debugging for flow exporters.packets
(Optional) The number of packets to debug for packet-level debugging of
flow exporters. The range is 1 to 65535.
number
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Examples
The following example indicates that a flow exporter packet has been queued for process send:
Device# debug flow exporter
May 21 21:29:12.603: FLOW EXP: Packet queued for process send
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
420
debug flow exporter

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English