Cisco Catalyst 3650 Series User Manual

vlan access-map
To create or modify a VLAN map entry for VLAN packet filtering, and change the mode to the VLAN
access-map configuration, use the vlan access-map command in global configuration mode on the switch
stack or on a standalone switch. To delete a VLAN map entry, use the no form of this command.
vlan access-map name [number]
no vlan access-map name [number]
This command is not supported on switches running the LAN Base feature set.Note
Syntax Description
Name of the VLAN map.
name
(Optional) The sequence number of the map entry that you want to create or modify (0
to 65535). If you are creating a VLAN map and the sequence number is not specified,
it is automatically assigned in increments of 10, starting from 10. This number is the
sequence to insert to, or delete from, a VLAN access-map entry.
number
Command Default
There are no VLAN map entries and no VLAN maps applied to a VLAN.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
In global configuration mode, use this command to create or modify a VLAN map. This entry changes the
mode to VLAN access-map configuration, where you can use the match access-map configuration command
to specify the access lists for IP or non-IP traffic to match and use the action command to set whether a match
causes the packet to be forwarded or dropped.
In VLAN access-map configuration mode, these commands are available:
• action—Sets the action to be taken (forward or drop).
• default—Sets a command to its defaults.
• exit—Exits from VLAN access-map configuration mode.
• match—Sets the values to match (IP address or MAC address).
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
843
vlan access-map

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English