Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
This is an example of output from the show interfaces accounting command:
This is an example of output from the show interfaces capabilities command for an interface:
This is an example of output from the show interfaces interface description command when the interface
has been described as Connects to Marketing by using the description interface configuration command:
Device# show interfaces gigabitethernet1/0/2 description
Interface Status Protocol Description
Gi1/0/2 up down Connects to Marketing
This is an example of output from the show interfaces etherchannel command when port channels are
configured on the switch:
This is an example of output from the show interfaces interface-id pruning command when pruning is enabled
in the VTP domain:
Device# show interfaces gigabitethernet1/0/2 pruning
Port Vlans pruned for lack of request by neighbor
Gi1/0/2 3,4
Port Vlans traffic requested of neighbor
Gi1/0/2 1-3
This is an example of output from the show interfaces stats command for a specified VLAN interface:
Device# show interfaces vlan 1 stats
Switching path Pkts In Chars In Pkts Out Chars Out
Processor 1165354 136205310 570800 91731594
Route cache 0 0 0 0
Total 1165354 136205310 570800 91731594
This is an example of partial output from the show interfaces status command. It displays the status of all
interfaces:
These are examples of output from the show interfaces status command for a specific interface when private
VLANs are configured. Port 22 is configured as a private-VLAN host port. It is associated with primary
VLAN 20 and secondary VLAN 25:
Device# show interfaces gigabitethernet1/0/22 status
Port Name Status Vlan Duplex Speed Type
Gi1/0/22 connected 20,25 a-full a-100 10/100BaseTX
In this example, port 20 is configured as a private-VLAN promiscuous port. The display shows only the
primary VLAN 20:
Device# show interfaces gigabitethernet1/0/20 status
Port Name Status Vlan Duplex Speed Type
Gi1/0/20 connected 20 a-full a-100 10/100BaseTX
This is an example of output from the show interfaces status err-disabled command. It displays the status
of interfaces in the error-disabled state:
Device# show interfaces status err-disabled
Port Name Status Reason
Gi1/0/2 err-disabled gbic-invalid
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
79
show interfaces