errdisable recovery cause
To enable the error-disabled mechanism to recover from a specific cause, use the errdisable recovery cause
command in global configuration mode. To return to the default setting, use the no form of this command.
errdisable recovery cause {all| arp-inspection| bpduguard| channel-misconfig| dhcp-rate-limit| dtp-flap|
gbic-invalid| inline-power| l2ptguard| link-flap| loopback| mac-limit| pagp-flap| port-mode-failure|
pppoe-ia-rate-limit| psecure-violation| security-violation| sfp-config-mismatch| storm-control| udld|
vmps}
no errdisable recovery cause {all| arp-inspection| bpduguard| channel-misconfig| dhcp-rate-limit|
dtp-flap| gbic-invalid| inline-power| l2ptguard| link-flap| loopback| mac-limit| pagp-flap|
port-mode-failure| pppoe-ia-rate-limit| psecure-violation| security-violation| sfp-config-mismatch|
storm-control| udld| vmps}
Syntax Description
Enables the timer to recover from all error-disabled causes.all
Enables the timer to recover from the Address Resolution Protocol
(ARP) inspection error-disabled state.
arp-inspection
Enables the timer to recover from the bridge protocol data unit
(BPDU) guard error-disabled state.
bpduguard
Enables the timer to recover from the EtherChannel misconfiguration
error-disabled state.
channel-misconfig
Enables the timer to recover from the DHCP snooping error-disabled
state.
dhcp-rate-limit
Enables the timer to recover from the Dynamic Trunking Protocol
(DTP) flap error-disabled state.
dtp-flap
Enables the timer to recover from an invalid Gigabit Interface
Converter (GBIC) module error-disabled state.
This error refers to an invalid small form-factor pluggable
(SFP) error-disabled state.
Note
gbic-invalid
Enables the timer to recover from the Power over Ethernet (PoE)
error-disabled state.
This keyword is supported only on switches with PoE ports.
inline-power
Enables the timer to recover from a Layer 2 protocol tunnel
error-disabled state.
l2ptguard
Enables the timer to recover from the link-flap error-disabled state.link-flap
Enables the timer to recover from a loopback error-disabled state.loopback
Enables the timer to recover from the mac limit error-disabled state.mac-limit
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
38
errdisable recovery cause
To Next Page
Loading...
Need help?
General