Cisco Catalyst 3650 Series User Manual

power supply
To configure and manage the internal power supplies on a switch, use the power supply command in privileged
EXEC mode.
power supply stack-member-number slot {A| B} {off| on}
Syntax Description
Stack member number for which to configure the internal power
supplies. The range is 1 to 9, depending on the number of switches
in the stack.
This parameter is available only on stacking-capable switches.
stack-member-number
Selects the switch power supply to set.slot
Selects the power supply in slot A.A
Selects the power supply in slot B.
Power supply slot B is the closest slot to the outer edge
of the switch.
Note
B
Sets the switch power supply to off.off
Sets the switch power supply to on.on
Command Default
The switch power supply is on.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SE
Usage Guidelines
The power supply command applies to a switch or to a switch stack where all switches are the same platform.
In a switch stack with the same platform switches, you must specify the stack member before entering the
slot {A | B} off or on keywords.
To return to the default setting, use the power supply stack-member-number on command.
You can verify your settings by entering the show env power privileged EXEC command.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
65
power supply

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English