Cisco Catalyst 3650 Series User Manual

snmp-server enable traps power-ethernet
To enable SNMP power-over-Ethernet (PoE) traps, use the snmp-server enable traps power-ethernet
command in global configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps power-ethernet {group number | police}
no snmp-server enable traps power-ethernet {group number | police}
Syntax Description
Enables inline power group-based traps for the specified group number.
Accepted values are from 1 to 9.
group number
Enables inline power policing traps.police
Command Default
The sending of power-over-Ethernet SNMP traps is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples
This example shows how to enable power-over-Ethernet traps for group 1:
Device(config)# snmp-server enable traps poower-over-ethernet group 1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
550
snmp-server enable traps power-ethernet

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English