Cisco Catalyst 3650 Series User Manual

snmp-server enable traps storm-control
To enable SNMP storm-control trap parameters, use the snmp-server enable traps storm-control command
in global configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps storm-control {trap-rate number-of-minutes}
no snmp-server enable traps storm-control {trap-rate}
Syntax Description
(Optional) Specifies the SNMP storm-control trap rate in minutes.
Accepted values are from 0 to 1000.
trap-rate number-of-minutes
Command Default
The sending of SNMP storm-control trap parameters is disabled.
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples
This example shows how to set the SNMP storm-control trap rate to 10 traps per minute:
Device(config)# snmp-server enable traps storm-control trap-rate 10
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
554
snmp-server enable traps storm-control

Cisco Catalyst 3650 Series Specifications

General

Brand	Cisco
Model	Catalyst 3650 Series
Category	Switch
Language	English