2000/3000 SHEET FINISHERS (B700/B701) 15 February 2006
1-84
Auxiliary Trays
The auxiliary trays are stored in the auxiliary tray storage pocket mounted on the
back cover of the finisher.
Make sure that the customer understands the following points about these auxiliary
trays:
• The trailing edges of excessively curled or Z-folded paper can activate the tray
full sensors before the tray is actually full.
• Once the "Exit Tray Full" message displays, the job cannot continue until some
sheets are removed from the tray which is only partially full. The trays are
designed to prevent this problem.
• The auxiliary tray for the shift tray should be installed for Z-folding jobs.
• The auxiliary tray for the proof tray should be installed only when excessively
curled paper is triggering early "Exit Tray Full" alerts.
• Normally, both auxiliary trays should be placed in the pocket mounted on the
back of the finisher.
Proof Exit Auxiliary Tray
Follow the procedures below to install the auxiliary tray for the proof tray.
1. First, remove the paper form the paper feed tray, turn it upside down, and
continue printing. This may solve the problem.
2. If the "Exit Tray Full" alerts continue,
set the proof auxiliary tray [A] on the
proof tray on the top of the finisher.
3. Make sure that the arms " of the
auxiliary tray fit tightly over the ridges
# of the proof tray below.
B246I903.WMF
[A]
"
#
To Next Page
Loading...
Need help?
General
