15 February 2006 SERVICE PROGRAM MODE TABLES
5-67
Service
Tables
SP5xxx Mode
5024* mm/inch Display Selection
Selects the unit of measurement.
After selection, turn the main power switch off and on.
[0~1/1]
0: mm
1: inch
5037 Status Lamp Detection
Enables or disables the function of the status lamp installed above the operation
panel.
[0~1/1]
0: Off: Disabled
1: On: Enabled
This status lamp requires special ordering and installation for this machine.
5045 Accounting Counter
Selects the counting method if the meter charge mode is enabled with SP5-930-
001.
Note: You can change the setting only one time.
[0 to 1/ 1]
0: Development counter. Shows the total counts for color (Y,M,C) and black (K).
1: Paper counter. Shows the total page counts for: Color Total, Black Total, Color
Copies, Black Copies, Color Prints, Black Prints.
5047 Reverse Display
001 Reverse Paper
Display
Determines whether the tray loaded with paper printed on
one side is displayed on the operation panel.
[0~1/0/1]
0: Not displayed
1: Displayed
002 Punched Paper
Determines whether the tray loaded with punched paper is
displayed on the operation panel.
[0~1/1/1]
0: Disable
1: Enable
To Next Page
Loading...
Need help?
General
