15 February 2006 COVER INTERPOSER TRAY (B704)
1-91
Installation
1.16.2 INSTALLATION PROCEDURE
The Cover Interposer Tray B704 can be installed on only of the following finishers:
• 2000-Sheet Booklet Finisher B700
• 3000-Sheet Finisher B701
• 3000-Sheet Finisher B706
Removing Tapes and Retainers
!WARNING!
Make sure that the finisher is disconnected from the main machine and that
the copier is switched off and unplugged before starting the following
procedure.
1. If the finisher is connected to the machine, disconnect it.
2. Remove all tape and retainers from the cover interposer tray [A].
3. Remove the tape and cardboard [B] from the ground connector.
B704I102.WMF
[A]
[B]
To Next Page
Loading...
Need help?
General
