MFP OPTIONS: B140/B246 SERIES 15 February 2006
1-170
1.23.10 DATA OVERWRITE SECURITY UNIT (B735)
ACCESSORY CHECK
Check the accessories and their quantities against this list:
Description Q’ty
1. SD Card................................................................................. 1
Before You Begin…
1. Confirm that the Data Overwrite Security unit SD card is the correct type for the
machine. The correct type for this machine is type "C".
Important: IF THE NVRAM IS REPLACED THEN THE DATA OVERWRITE SECURITY
FEATURE MUST BE REPLACED WITH THE NEW DATA OVERWRITE SECURITY OPTION
.
2. Make sure that the following settings are not at the factory default settings:
• Supervisor login password
• Administrator login name
• Administrator login password
Important: These settings must be set up by the customer before the Data
Overwrite Security unit can be installed.
3. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator
Authentication Management"> "Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you
can do the installation procedure.
4. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator
Authentication Management"> "Available Settings
NOTE: "Available Settings" is not displayed until Step 2 is done.
If this setting is not selected tell the customer that this setting must be selected
before you can do the installation procedure.
To Next Page
Loading...
Need help?
General
