OVERVIEW 15 February 2006
4-2
4.1.1 RECOVERY METHODS
When an error occurs during downloading, an error code is displayed on the
operation panel.
• If the download procedure can be re-started, re-start the download procedure.
• If the download procedure cannot be downloaded for other than the GW
controller, replace the board where the downloaded program is stored.
• If the download procedure cannot be downloaded for the GW controller, set DIP
SW 1 to ON. Power the machine off and on to start the downloading program.
After downloading has completed, set the DIP SW to OFF then power the
machine off and on again.
4.1.2 IMPORTANT SP CODES
SP5802 Free Run Mode Execute this SP to force base engine
to run in the free run mode for testing.
SP5803 Input Check Displays the signals received from
sensors and switches. Refer to the
detailed tables in Section "5. Service
Tables”.
SP5804 Output Check Switches electrical components one by
one for testing. Refer to the detailed
tables in Section "5. Service Tables”.
SP5990 SMC Printout Prints the SMC Report. Some SC
codes (logged SPs) are shown only in
the SMC Report and do not show on
the operation panel display.
SP7801 ROM Version Display. Displays the version number of the
main machine and connected
peripherals.
SP7832 Self-Diagnostic Result
Display
Execute this SP to display a list of
error codes. No errors have occurred if
nothing is displayed.
SP7911 (B064)
SP7801 (B140/B246)
Firmware Version Displays the current numbers of all
versions of the firmware in the system.
SP7990 (B064)
SP7403 (B140/B246)
Status of Issued SC Execute to display the following
information about the most recently
issued SC: 1) Source file name, 2) SC
number, 3) Result
NOTE: For more information about these and other SP codes, see “4. Service
Tables”.
To Next Page
Loading...
Need help?
General
