MFP OPTIONS: B246 SERIES 15 February 2006
1-186
1.24.9 DATA OVERWRITE SECURITY UNIT TYPE C B735
ACCESSORY CHECK
Check the accessories and their quantities against this list:
Description Q’ty
1. SD Card................................................................................. 1
Before You Begin…
1. Confirm that the Data Overwrite Security unit SD card is the correct type for the
machine. The correct type for this machine is type "E".
Important: DO THIS NOW. IF YOU INSTALL ANY VERSION OTHER THAN TYPE "E", YOU
WILL HAVE TO REPLACE THE
NVRAM AND DO THIS INSTALLATION PROCEDURE AGAIN.
2. Make sure that the following settings are not at the factory default settings:
• Supervisor login password
• Administrator login name
• Administrator login password
Important: These settings must be set up by the customer before the Data
Overwrite Security unit can be installed.
3. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator
Authentication Management"> "Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you
can do the installation procedure.
4. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator
Authentication Management"> "Available Settings
NOTE: "Available Settings" is not displayed until Step 2 is done.
If this setting is not selected tell the customer that this setting must be selected
before you can do the installation procedure.
To Next Page
Loading...
Need help?
General
