15 February 2006 MFP OPTIONS: B064 SERIES
1-141
Installation
USB SP Settings
The following SP commands are available. However, only one setting may require
adjustment and this setting should be performed only if the customer is
experiencing USB data transmission errors.
NOTE: Do not change the settings marked “DFU”. These settings are for design
and factory use only.
To enter the SP mode:
1. Press Clear Modes "
2. On the operation panel keypad, press #$%.
3. Hold down Clear/Stop & for more than 3 seconds.
4. Press “Copy SP” on the touch-panel to open the SP command selection
screen.
5. Enter '()).
SP No. Name Function
Adjusts the USB transfer rate. Do not change the setting
unless there is a data transfer error using the USB high
speed mode.
HS/FS:
High speed/Full speed auto adjust
(480Mbps/12Mbps)
5844-001 Transfer Rate
FS: Full speed (12Mbps fixed)
5844-002 Vendor ID
Displays the vendor ID. DFU
5844-003 Product ID
Displays the product ID. DFU
5844-004 Dev. Release Num
Displays the development release version number. DFU
Exit
SP Mode (Service)
Close All Copy Window SP DirectOpen All
X-XXX-XXX
SP2XXX
SP3XXX
SP5XXX
SP6XXX
SP7XXX
SP8XXX
SP4XXX
SP1XXX
Group
Page
Line
Page
Line
Group
21
COPY: SP1-001-001
Initial 0
Prev Page Next Page
14APR 2002 03:25
Feed
Drum
Process
Data Log2
Scanner
Mode
Periphs
Data Log
B064I999.WMF
To Next Page
Loading...
Need help?
General
