GENERAL CAUTIONS 15 February 2006
3-4
3.1.8 CLEANING
1. When servicing the cleaning section, be careful not to damage the edge of the
cleaning blade.
2. Do not touch the cleaning blade with bare hands.
3. Before disassembling the cleaning section, place a sheet of paper under it to
catch any toner falling from it.
3.1.9 FUSING UNIT
1. After installing the fusing thermistor, make sure that it is in contact with the hot
roller and that it is movable.
2. Be careful not to damage the edges of the hot roller strippers or their tension
springs.
3. Do not touch the fusing lamp and rollers with bare hands.
4. Make sure that the fusing lamp is positioned correctly and that it does not touch
the inner surface of the hot roller.
3.1.10 PAPER FEED
1. Do not touch the surface of the pick-up, feed, and separation rollers.
2. To avoid paper misfeeds, the side fences and end fence of the paper tray must
be positioned correctly to align with the actual paper size.
3.1.11 USED TONER
1. We recommend checking the amount of used toner at every EM.
2. Dispose of used toner in accordance with local regulations. Never throw toner
into an open flame, for toner dust may ignite.
To Next Page
Loading...
Need help?
General
