SOFTWARE UPDATE 15 February 2006
5-16
5.4 SOFTWARE UPDATE
The cards that are necessary for the software update, and the update procedures,
are different for each machine:
Machine Card Procedure
B140 Series/B246 Series SD Card (☛ 5.4.1)
B064 Series IC Memory Card (☛ 5.4.2)
For more, refer to the applicable section below.
5.4.1 SOFTWARE UPDATE PROCEDURE: B140/B246 SERIES
SD cards are used with the B140/B246 Series to update the software and to back
up important data. Here is a list of the firmware modules that can be updated or
restored from an SD card:
• GW controller software
• BCU software
• LCDC (operation panel) software
• Network Sys (network) software
• Web Sys (Web Image Monitor)
• Document Server software
• NFA (Net File) software
• Printer application software
• Scanner application software
• DESS (encryption module) software
Important:
Here are some important points to remember when you use IC cards or SD cards.
• Never connect or remove an IC card or SD card with the machine power turned
on.
• Never turn the power off while the machine is downloading data from an IC card
or SD card.
• The IC cards and SD card are precision items. Use them carefully.
• Never store IC cards or SD cards in a location where they are exposed to high
temperature, high humidity, or direct sunlight.
• Never bend an IC card or SD card, scratch it, or expose it to strong vibration.
• Before uploading data to an SD card, always confirm that its write-protect switch
is off.
To Next Page
Loading...
Need help?
General
