15 February 2006 MFP OPTIONS: B064 SERIES
1-151
Installation
1.22.7 FILE FORMAT CONVERTER (MLB) (B519)
NOTE:
1. This table shows the special firmware versions to use with the Copy Connector
Kit or File Format Converter (MLB option). When you install one of these
options, it is necessary to install these firmware modules together as a set.
Software Part Number Version (1st released)
GW Controller: System B5254108 5.07
GW Controller: Copy B5254109 5.07
BCU B5254123 5.03d
Printer/Scanner B5255204 4.15/5.00
NIB/Netfile B5254114 3.00/1.79
B5254176 (NA)
LCDC
B5254177 (EU)
2.04
2. With the Copy Connector/MLB modifications, the machine firmware is divided
into 2 main groups:
1) The Copy Connector/MLB group (this starts with the versions in the table
above)
2) The usual firmware that was used until this time, that is, for machines without
the Copy Connector or MLB options.
Important: Do not mix firmware from these two. Always use firmware from the
same group, or the machine will not operate correctly.
3. The MLB option cannot operate with any of these items installed. You must
remove these before you start the procedure below:
- Wireless LAN board
- IEEE1394 I/F board
- USB2.0 I/F board
- Copy Connector Kit components
4. As shown above, the GW controller firmware for the Copy Connector/MLB
group is divided into GW System and GW Copy. This is because the firmware
is too large to go on one card.
To Next Page
Loading...
Need help?
General
