ENERGY SAVER MODES 15 February 2006
6-138
6.14.4 AUTO OFF MODE
Auto off mode is used only if no optional printer/scanner unit is installed.
Entering auto off mode
The machine enters auto off mode when one of the following is done.
• The auto off timer runs out after the last job (User Tools – System Settings –
Timer Setting – Auto Off Timer: default setting is 90 min)
• The operation switch is pressed to turn the power off
What happens in auto off mode
When the machine enters auto off mode, the main power switch turns off
automatically. The fusing lamp and all dc supplies except +5VE (+5V for energy
saver mode) turn off.
Returning to stand-by mode
The machine returns to stand-by mode when the main power switch is turned on.
Operation
Switch
Energy
Saver LED
Fusing Temp.
Approx.
Recovery
Time
System
+5V
Note
Off Off
Room Temp.
(Fusing lamp off)
300 s
Off
Only +5VE is
supplied to the BICU.
Disabling auto off mode
If the user wishes to disable auto off mode, use the following user tool: User Tools
– System Settings – AOF (change the setting to “OFF”).
To Next Page
Loading...
Need help?
General
