framing (E3)
To select the frame type for E3 data lines, use the framing command in E3 configuration mode. To disable
E3 framing, use the no form of this command.
framing {g751| g832}
no framing {g751| g832}
Syntax Description
Specifies that G.751 framing is used as the E3 framing type. The default is G.751.g751
Specifies that G.832 framing is used as the E3 framing type.g832
Command Default
The default is G.751.
Command Modes
E3 configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
If you do not use the framing command, the default is used by the E3 controllers to automatically determine
the framing type received from the far-end equipment. You can also set the framing for each T1/E1 channel
by using the framing command in T1 or E1 configuration mode.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
The following example shows how to select G751 as the E3 frame type:
RP/0/RSP0/CPU0:router(config)# controller e3 0/6/0/0
RP/0/RSP0/CPU0:router(config-e3)# framing g751
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1004
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
framing (E3)
To Next Page
Loading...
Need help?
General
