interface (global)
To configure an interface or to create or configure a virtual interface, use the interface command in global
configuration mode. To delete the interface configuration, use the no form of this command.
interface type interface-path-id
no interface type interface-path-id
Syntax Description
Interface type. For more information, use the question mark (?) online help function.
type
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?) online
help function.
interface-path-id
Command Default
No interfaces are configured
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The interface command enters interface configuration mode to allow you to configure interfaces. If a virtual
interface is configured, then the interface is created if it did not already exist.
The no form of this command applies only to virtual interfaces or to subinterfaces (that is, interfaces that have
been created in global configuration mode).
Task ID
OperationsTask ID
read, writeinterface
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
501
Global Interface Commandsonthe Cisco ASR 9000 Series Router
interface (global)
To Next Page
Loading...
Need help?
General
