frame-relay lmi-n391dte
To set the full status polling interval, use the frame-relay lmi-n391dte command in interface configuration
mode. To restore the default interval value, use the no form of this command.
frame-relay lmi-n391dte polling-cycles
no frame-relay lmi-n391dte polling-cycles
Syntax Description
Number of Line Integrity Verification (LIV) exchanges performed before
requesting a full status message. Range is from 1 to 255. The default is 6.
polling-cycles
Command Default
The full status polling interval is 6.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the frame-relay lmi-n391dte command to set the full status message polling interval. This command is
relevant only when the interface type is data terminal equipment (DTE).
Two message types are supported: status inquiry and status. Status inquiry messages are sent from DTE to
DCE. Status messages are sent from DCE to DTE (in response to a status inquiry). The Status (Full) and LIV
report types are contained within these messages, and typically there is one status transaction for every five
LIV transactions.
This command is available on Packet-over-SONET/SDH (POS), serial, and multilink interfaces.
Task ID
OperationsTask ID
read, writefr
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
434
Frame Relay Commands on the Cisco ASR 9000 Series Router
frame-relay lmi-n391dte
To Next Page
Loading...
Need help?
General
