lldp holdtime
To specify the length of time that information from a Link Layer Discovery Protocol (LLDP) packet should
be held by the receiving device before aging and removing it, use the lldp holdtime command in global
configuration mode. To return to the default, use the no form of this command.
lldp holdtime seconds
no lldp holdtime seconds
Syntax Description
Number from 0 to 65535 that specifies the amount of time (in seconds) to hold the
packet information. The default is 120.
seconds
Command Default
The packet hold time is 120 seconds (2 minutes).
Command Modes
Global configuration (config)
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeethernet-services
Examples
This example shows how to change the default hold time to 1 minute:
RP/0/RSP0/CPU0:router(config)# lldp holdtime 60
Related Commands
DescriptionCommand
Enables LLDP globally for both transmit and receive operation on
the system.
lldp, on page 87
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
90
Ethernet Interface Commands on the Cisco ASR 9000 Series Router
lldp holdtime
To Next Page
Loading...
Need help?
General
