g709 tim-to-client-gais
To insert a Generic Alarm Indication Signal (GAIS) on the client side when a Trace Identifier Mismatch
(TIM) is detected, use the g709 tim-to-client-gais command in DWDM configuration mode. To disable this
feature, use the no form of this command.
g709 tim-to-client-gais
no g709 tim-to-client-gais
Syntax Description
This command has no keywords or arguments.
Command Default
By default, no GAIS to client is inserted.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writedwdm
Examples
The following example shows how to configure a GAIS to client when a TIM is received:
RP/0/RSP0/CPU0:router(config)# controller dwdm 0/1/0/0
RP/0/RSP0/CPU0:router(config-dwdm)# g709 tim-to-client-gais
Related Commands
DescriptionCommand
Displays optical parameters, G.709 alarms and counters, and register
and module information for a DWDM controller.
show controller dwdm, on page 56
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
21
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 tim-to-client-gais
To Next Page
Loading...
Need help?
General
