Cisco A9K-SIP-700 Command Reference Guide

proactive trigger threshold
To configure the trigger threshold of Forward Error Correction-Fast Re-Route (FEC-FRR), use the proactive
trigger threshold command in DWDM configuration mode. To remove the trigger threshold, use the no form
of this command.
proactive trigger threshold x-coefficient y-power
no proactive trigger threshold x-coefficient y-power
Syntax Description
Bit error rate coefficient (x of xE-y) . The range is 1 to 9. Default is 1.x-coefficient
Bit error rate exponent (y of xE-y). The range is 3 to 9.y-power
Command Default
No default behavior or values
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Support for proactive trigger threshold command was included on these
Modular Port Adaptors(MPAs):
•
A9K-MPA-2X40GE
•
A9K-MPA-1X40GE
Release 4.2.3
Usage Guidelines
The proactive feature is used to trigger Forward Error Correction-Fast Re-Route (FEC-FRR).
The proactive trigger threshold command is supported on the legacy line cards but does not function
on the A9K-8X100GE-SE line cards though it is supported on them.
Note
To see the proactive status, use the show controller dwdm proactive status command.
Task ID
OperationsTask ID
read, writedwdm
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
52
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
proactive trigger threshold

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English