controller wanphy
To enter WAN physical controller configuration mode in which you can configure a 10-Gigabit Ethernet
WAN PHY controller, use the controller wanphy command in global configuration mode. To return the
10-Gigabit Ethernet WAN PHY controller to its default WAN mode configuration, use the no form of this
command.
controller wanphy interface-id
no controller wanphy interface-id
Syntax Description
Physical interface instance. Naming notation is rack/slot/module/port and a slash between
values is required as part of the notation.
•
rack: Chassis number of the rack.
•
slot: Physical slot number of the line card.
•
module: Module number. A physical layer interface module (PLIM) is always 0. Shared
port adapters (SPAs) are referenced by their subslot number.
•
port: Physical port number of the interface.
For more information about the syntax for the router, use the question mark (?) online help
function.
interface-id
Command Default
No default behavior or values
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
After you use the no controller wanphy command to return a 10-Gigabit Ethernet WAN PHY controller
to its default configuration, you need to cycle the power to the 10-Gigabit Ethernet SPA for the mode
configuration changes to take effect.
Note
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1100
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
controller wanphy
To Next Page
Loading...
Need help?
General
