Cisco A9K-SIP-700 Command Reference Guide

lacp collector-max-delay
To configure the maximum period of wait time between sending of two subsequent Ethernet frames on a link,
enter the lacp collector-max-delay command in interface configuration mode. To return to the default, use
the no form of this command.
lacp collector-max-delay delay-in-tens-of-microseconds
no lacp collector-max-delay delay-in-tens-of-microseconds
Syntax Description
Length of wait time, in tens of microseconds. The range is from 0
to 65535. The default is 0xFFFF.
delay-in-tens-of-microseconds
Command Default
The collector-max-delay time is not configured.
Command Modes
Interface configuration (config-if)
Command History
ModificationRelease
This command was introduced.Release 5.1.3
Task ID
OperationTask ID
read, writebundle
Examples
The following example shows how to configure the maximum period of wait time between sending of two
subsequent Ethernet frames on a link:
RP/0/RSP0/CPU0:router(config)# interface Bundle-Ether 100
RP/0/RSP0/CPU0:router(config-if)# lacp collector-max-delay 500
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
595
Link Bundling Commands on the Cisco ASR 9000 Series Router
lacp collector-max-delay

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English