clear controller lnm
To clear link noise monitoring statistics or reset states, use the clear controller lnm command in EXEC
configuration mode.
clear controller {t1| e1} interface-path-id lnm {state| statistics}
Syntax Description
Specifies clearing of LNM states or statistics for a T1 controller.t1
Specifies clearing of LNM states or statistics for an E1 controller.e1
Physical interface or virtual interface.
Use the show controllers command to see a list of all controllers currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
Resets the LNM event states for the specified controller.state
Clears the LNM statistics for the specified controller and resets them to zero.statistics
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When specifying a channelized T1 controller, use the following guidelines for the interface-path-id:
•
The naming notation is rack/slot/module/port/T3Num/T1num.
•
The slash between values is required as part of the notation.
•
The following list describes the components of the notation:
◦ rack—Chassis number of the rack.
◦ slot—Physical slot number of the line card.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
959
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
clear controller lnm
To Next Page
Loading...
Need help?
General
