Cisco A9K-SIP-700 Command Reference Guide

bert t3
To start or stop a configured bit error rate test (BERT) on a T3 controller or channel group, use the bert t3
command in EXEC mode.
bert t3 interface-path-id [error] {start| stop}
Syntax Description
Physical interface or virtual interface.
Use the show interfaces command to see a list of all interfaces currently
configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface-path-id
(Optional) Injects errors into the running BERT stream.error
Starts the BERT on the T3 controller or channel.start
Stops the BERT on the T3 controller or channel.stop
Command Default
No default behavior or values
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
For the interface-path-id argument, use the following guidelines:
•
If specifying a physical interface, the naming notation is rack/slot/module/port. The slash between values
is required as part of the notation. An explanation of each component of the naming notation is as follows:
◦
rack: Chassis number of the rack.
◦
slot: Physical slot number of the line card.
◦
module: Module number. A physical layer interface module (PLIM) is always 0.
◦
port: Physical port number of the interface.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
953
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
bert t3

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English