framing (SONET)
To specify the framing used on the SONET controller, use the framing command in SONET/SDH configuration
mode. To disable framing on the SONET controller, use the no form of this command.
framing {sdh| sonet}
no framing {sdh| sonet}
Syntax Description
Selects Synchronous Digital Hierarchy (SDH) framing. This framing mode is typically
used in Europe.
sdh
Selects SONET framing. This is the default.sonet
Command Default
The default framing on SONET controllers is sonet.
Command Modes
SONET/SDH configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
The sdh keyword was supported.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the framing command to select either SONET or SDH framing on the selected physical port, if supported.
For physical ports that do not support either of these two options, the framing command is disabled.
Use the no form of this command to disable SONET or SDH framing on the SONET controller.
Task ID
OperationsTask ID
read, writesonet-sdh
Examples
In the following example, the SONET controller is configured for SDH framing:
RP/0/RSP0/CPU0:router(config)# controller sonet 0/2/0/2
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
864
SONET Controller Commands on the Cisco ASR 9000 Series Router
framing (SONET)
To Next Page
Loading...
Need help?
General
