Examples
The following example shows how to configure LACP priority on a port:
RP/0/RSP0/CPU0:router# config
RP/0/RSP0/CPU0:router(config)# interface gigabitethernet 0/1/0/1
RP/0/RSP0/CPU0:router(config-if)# bundle port-priority 1
Related Commands
DescriptionCommand
Adds a port to an aggregated interface or bundle.bundle id, on page 572
Displays detailed information about LACP ports and their
peers.
show lacp bundle, on page 645
show lacp port, on page 656
Displays the local system ID used by the LACP.show lacp system-id, on page 659
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
584
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle port-priority
To Next Page
Loading...
Need help?
General
