Cisco A9K-SIP-700 Command Reference Guide

g709 enable
To enable the ITU-T G.709 wrapper, use the g709 enable command in DWDM configuration mode. To
disable the ITU-T G.709 wrapper, use the no form of this command.
g709 enable
nog709 enable
Syntax Description
This command has no keywords or arguments.
Command Default
The G.709 wrapper is disabled.
Command Modes
DWDM configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
Task ID
OperationTask ID
read, writedwdm
Examples
This example shows how to enable the G.709 wrapper on an interface:
RP/0/RP0/CPU0:Router(config)# controller dwdm 0/5/0/0
RP/0/RP0/CPU0:Router(config-dwdm)# g709 enable
RP/0/RP0/CPU0:Router(config-dwdm)# admin-state in-service
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
8
Dense Wavelength Division Multiplexing Commands on the Cisco ASR 9000 Series Router
g709 enable

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English