pos
To access the POS configuration submode, use the pos command in interface configuration mode.
pos
Command Default
No default behavior or values
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
When you issue the pos command in interface configuration mode for a POS interface, the CLI prompt changes
to “config-if-pos,” indicating that you have entered POS configuration submode. In the following sample
output, the question mark (?) online help function displays all the commands available under POS configuration
submode:
RP/0/RSP0/CPU0:router(config)# interface POS 0/1/0/2
RP/0/RSP0/CPU0:router(config-if)# POS
RP/0/RSP0/CPU0:router(config-if-pos)# ?
commit Commit the configuration changes to running
crc Set the CRC on a POS interface
describe Describe a command without taking real actions
do Run an exec command
exit Exit from this submode
no Negate a command or set its defaults
show Show contents of configuration
transmit-delay Set POS transmit delay on an interface
Task ID
OperationsTask ID
read, writepos-dpt
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
702
Packet-over-SONET Interface Commands on the Cisco ASR 9000 Series Router
pos
To Next Page
Loading...
Need help?
General
