Cisco A9K-SIP-700 Command Reference Guide

refresh max-time
To configure the maximum time allowed between context refreshes, use the refresh max-time command in
IPHC profile configuration mode. To return to the default context refresh settings, use the no form of this
command.
refresh max-time {max-time| infinite}
no refresh max-time [max-time| infinite]
Syntax Description
Time, in seconds, between context refreshes. Range is from 0 to 255.
max-time
Allows an unlimited time to pass between context refreshes.infinite
Command Default
max-time: 5
Command Modes
IPHC profile configuration
Command History
ModificationRelease
This command was introduced.Release 4.0.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To enable the configured context refresh settings for RTP packets, the refresh rtp command must be used.
The maximum time between context refreshes can be set only within an IPHC profile.Note
Task ID
OperationsTask ID
read, writeip-services
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
803
Serial Interface Commands on the Cisco ASR 9000 Series Router
refresh max-time

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English