mdl
To configure the Maintenance Data Link (MDL) message defined in the ANSI T1.107a-1990 specification,
use the mdl command in T3 configuration mode. To remove the message, use the no form of this command.
{mdl string {eic| fi| fic| gen-number| lic| port-number| unit} string| transmit {idle-signal| path| test-signal}
{disable| enable}}
{no mdl string {eic| fi| fic| gen-number| lic| port-number| unit} string| transmit {idle-signal| path|
test-signal} {disable| enable}}
Syntax Description
Specifies the Equipment Identification Code; can be up to 10 characters.
string eic string
Specifies the Facility Identification Code sent in the MDL Path message;
can be up to 38 characters.
string fi string
Specifies the Frame Identification Code; can be up to 10 characters.
string fic string
Specifies the Generator number string sent in the MDL Test Signal
message; can be up to 38 characters.
string gen-number string
Specifies the Location Identification Code; can be up to 11 characters.
string lic string
Specifies the Port number string sent in the MDL Idle Signal message;
can be up to 10 characters.
string port-number string
Specifies the Unit Identification Code; can be up to 6 characters.
string unit string
Specifies the transmission of the MDL Idle Signal message.transmit idle-signal
Specifies the transmission of the MDL Path message.transmit path
Specifies the transmission of the MDL Test Signal message.transmit test-signal
Disables or enables transmission of the specified message.disable | enable
Command Default
No MDL message is configured.
Command Modes
T3 configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1027
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
mdl
To Next Page
Loading...
Need help?
General
